E6581737- 29 -3.4.6.6. fd01 (Inverter operating status 1 (real time))bit Function 0 1 Note0 Failure FL No output Under inprogress -1 Failure Not tripped TrippedTrip status includes rtry andthe trip retention status are alsoregarded as tripped statuses.2 Alarm No alarm Alarm issued -3 Under voltage (moff) Normal Under voltage -4 Motor selection (1 or 2)(THR 2 selection) Motor 1 (THR1) Motor 2 (THR2)THR1: pt = setting value, vl,vlv, vb, thrTHR2: pt = 0, f170, f171,f172, f1735 PID control off PID controlpermittedPID controlprohibits -6Acceleration/deceleration pattern selection (1 or2)Acceleration/deceleration pattern1 (AD1)Acceleration/deceleration pattern2 (AD2)AD1: acc, decAD2: f500, f5017 DC braking OFF Forced DCbraking -8 Jog run OFF Jog run -9 Forward / reverse run Forward run Reverse run -10 Run/stop Stop Run -11 Coast stop (ST = OFF) ST=ON ST=OFF -12 Emergency stop No emergencystop statusEmergencystop status -13 Standby ST=ON Start-up process StandbyStandby: Initializationcompleted, not failure stopstatus, not alarm stop status(moff, ll forced stop),ST=ON, and RUN=ON14 Standby Start-up process StandbyStandby: Initialization completed,not failure stop status and notalarm stop status (moff, llforced stop)15 (Undefined) - - -Note: The bit described "Undefined" is unstable. Don't use the bit for the judgment.3.4.6.7. fd00 (Output frequency (real time))The current output frequency is read into 0.01Hz of units and by the hexadecimal number.For example, when the output frequency is 80Hz, 0x1F40 (hexadecimal number) are read.Since the minimum unit is 0.01%,0x1F40 (Hex.) = 8000(Dec.) * 0.01 = 80 (Hz)Also about the following parameters, these are the same as this.- fd22 (Feedback value of PID (real time)) ............................. Unit: 0.01Hz- fd16 (Estimated speed (real time)) ....................................... Unit: 0.01Hz- fd29 (Input power (real time)) ............................................... Unit: 0.01kW- fd30 (Output power (real time)) ............................................ Unit: 0.01kW