Toshiba Compliant Manager BMS-CM1280TLE Installation Manual

Contents

– 15 –Compliant Manager Installation Manual• When a zone is selected, group numbers registered in the zone are displayed.• Groups whose numbers are displayed are already registered.• Even when addresses have been registered, the registration can be cancelled with the button.(4) Select the unit to be registered in the group selected in step (3).• Switch refrigeration system No.1 to 31 with the button, and then switch indoor unit No.1 to 64 with thebutton.• When no system exists, indoor unit number is displayed as “- -”.• System number 31 is for a local adapter and heat exchange ventilators. An indoor unit number is alwaysdisplayed regardless of whether the unit exists or not.(5) Press the button to register the setting or press the button to cancel the setting.(6) To continue registration, repeat steps (3) to (5).(7) Press the button to terminate the address setting.C Automatic settingSet central control addresses automatically from the Compliant Manager.(Central control addresses are set automatically in ascending order of unit number.)(1) Press the button and ZONE button simultaneously for at least 4 seconds.(CODE No. C1 flashes.)(2) Press the SET TEMP. or button to change the CODE No. to C2.(3) Press the button. (Central control addresses are automatically registered. This registration requires severalminutes. lights during this address setting.)(4) goes out and the indication of C2 flashes, which shows completion of the automatic addressregistration.(5) Press the button to exit the address setting mode.NOTEThis function is not available for custom air conditioners.For details, refer to the manual of the TCC-LINK adapter.(1) Press the button and ZONE button simultaneously for at least 4 seconds.(CODE No. C1 flashes.)(2) Press the SET TEMP. or button to change the CODE No. C3.(3) Press the button to start checking a duplicate central control address error. ( lights during thischeck.)(4) When goes out, the check has been completed.* When nothing appears in the group number display area at the end of checking, no duplicate address errorhas been detected.* When a group number in the group number display area flashes at the end of checking, a duplicate addresserror has been detected.(Correct the duplicate address.)14-EN