Setting the sleep timerThe sleep timer turns off tile TV automatically.To use the remote control to set the sleep timer:Repeatedly press TIMER to set the number of minutes until theTV turns off automatically (in 10-minute increments, to amaximum of 180).Note :To display the amount of time until the TVturns off automatically, press TIMER once.To close the display, press ENTER.TIMER30To use the menu system to set the sleep timer:1. Press TIMER (or MENU and • •) to display the CUSTOMmenu. TIMER will be highlighted.2. After tile number position starts to blink, use tile channelnumbers to enter the length of time until the TV turns off.3. Press ENTER to start the timer.®@®©@@CUSTOMFAVORITE OH1FAVORITE CH2CH LABELINGVIDEO LABELBACKGROUNDTo cancel the sleep timer:Press TIMER until the number is set to 0, use the menu systemto set the timer to 0, or turn off the TV.Setting the clockTo set tile clock:1. Press MENU, and then press • or • until the SET UP menuappears.2. Press • or • to highlight CLOCK SET.3. After the number position starts to blink, press the Numberbuttons (0-9) to enter the correct time. The clock operates on a12-hour cycle.4. Press ENTER to start the clock.®@®¢@®SET UPRECALLPOWERTIMERNumberMENUENTERAT< I_Note :If the power source for the TV is interrupted(for example, if the power cord is unpluggedor a power failure occurs), the clock will haveto be resetTV/CABLE CABLECH PROGRAMADD/ERASE ADDTo display the time on-screen:Press RECALL.