Toshiba 2000 User Manual

Also see for V Series: User manual User manual User manual User manual User manual

Contents

ii Computer module C2PU7 User’s Manual1.Markings used on the model 2000 and in this ManualMake sure warning markings are attached on the model 2000.If any of them are missing or the wording is illegible, contact Toshiba’s Service Department[Warning Mark on the model 2000]This is the warning mark for dangerous location. It is attached to theequipment at positions where there is a risk of electric shock and at positionswhere there is a risk of damage to the equipment through incorrect wiring.Take the following precautions where this mark is found.(1) Keep hands away from terminals, especially the input terminal of the power supply while power ison, to avoid the risk of electric shock.(2) Turn off power before installing or removing modules, terminal blocks, or wires.(3) Applying excess power voltage to the model 2000 can cause failure or malfunction. Apply power ofthe specified ratings described in this manual.(4) Turn off the power of the tool (a personal computer, etc.) before connecting the connector to thetool port. Afterwards, turn on power.Avoid short-circuiting between the tool connector pins with the cover, etc.[Safety Label]The safety label as shown on the left both in Japanese and Englishis attached to the power supply terminal of the model 2000. (exeptthe 24Vdc input power supply module)Remove the mount paper before wiringPeel off either of the Japanese and English labels from the mountpaper and stick it to the model 2000 or near the power terminalwhere it can be readily seen.In the event the seal is damaged, contact the dealer.Marks printed at pages in this manual should always be read carefully.Be sure to read them in handling your model 2000.Notes