Toro TX 1000 Operator's Manual

4. Route the loader end branch into the rear of themachine along the lower front end of the loaderarm valve assembly (Figure 11) and out throughthe right hose access (Figure 12).g242387Figure 111. Loader end branch 2. Right hose accessg242409Figure 121. Right hose access 3. Outer protective sleeve2. Loader end branch5. Route the loader end branch up into the outerprotective sleeve, then route it along the bottomof the inner hydraulic hose so that the wiresreach the 7-pin connector.6. Install the plug nut (large) and then the grommet(small, narrow end facing the 7-pin connector)over the wires.g242237Figure 131. Plug nut 2. Grommet7. Remove the top half of the 7-pin connector andinstall the 4 loader end wires into the correctconnector terminals inside as shown in Figure14.g242270Figure 141. Wire harness retainer 4. Yellow - Terminal 22. White - Terminal 6 5. Black - Terminal 73. Black - Terminal 510