Toro Reelmaster 3100-D Service Manual

Also see for 03200 Reelmaster 3100-D: Operator's manual Operator's manual Operator's manual Operator's manual Operator's manual

Rear Wheel Motor Test: (continued)g344968Figure 431. Rear wheel motor 2. Upper fitting1. Disconnect hose from the upper hydraulic fitting of the rear wheel motor(Figure 43).2. Install flow tester between the disconnected hydraulic hose and the rearwheel motor. Make sure the tester flow control valve is fully open.WARNINGBefore jacking up the machine, review and follow JackingInstructions (page 1–7).3. Raise off the floor and support both front wheels.4. Chock the rear wheel to prevent wheel rotation.5. Start the engine. Move throttle to full speed.CAUTIONUse extreme caution when performing wheel motor tests. The wheelmotors will be trying to move the machine forward.6. Sit in the operators seat, release the parking brake, and set theMow/Transport slide to the transport position.7. Slowly depress forward traction pedal until 68.9 to 103.4 Bar (1000 to 1500PSI) is displayed on the pressure gauge.Flow meter should read less than 5.7 LPM (1.5 GPM).8. Release traction pedal, shut engine off, and record test results.9. Rotate rear wheel 120 degrees and retest. Repeat this procedure until wheelmotor has been tested in three (3) different positions.10. If specifications are not met, repair or replace worn wheel motor.Hydraulic System: Testing Page 5–36 Reelmaster® 3100-D/3105-D20252SL Rev A