Toro Groundsmaster 5900 Installation Instructions Manual

Form No. 3429-577 Rev AContactor KitGroundsmaster® 5900 or 5910 Rotary MowerModel No. 139-1030Installation InstructionsInstallationLoose PartsUse the chart below to verify that all parts have been shipped.Procedure Description Qty. Use1 No parts required – Prepare the machine.2 No parts required – Disconnect the battery.3 No parts required – Remove the side panels.4 No parts required – Remove the 28-V solenoid.Contactor 1Contactor mount 1Cable 1Nut (1/4 inch) 4Nut (5/16 inch) 2Flange bolt 25Carriage bolt 2Install the contactor.Wire cap 1Wire label 1Vinyl cap 1Nut (M5) 16Cable tie 1Remove the I-terminal wire from thealternator.7 Molded cap 1 Remove the diode.8 Fuse (60 A) 1 Install the 60-A fuse.9 Fuse decal (Part No. 139-1031) 1 Install the decal.10 No parts required – Connect the battery.11 No parts required – Install the side panels and close thehood.12 No parts required – Verify that the 28-V system and cabpower (if equipped) are functioning.© 2019—The Toro® Company8111 Lyndale Avenue SouthBloomington, MN 55420Register at www.Toro.com. Original Instructions (EN)Printed in the USAAll Rights Reserved *3429-577* A