Menu
Toro GrandStand 74527 Operator's Manual
Also see for GrandStand 74527: Setup instructions
                                                    |
Charging the BatteryWARNINGCharging the battery produces gasses thatcan explode.Never smoke near the battery and keep sparksand flames away from battery.Important: Always keep the battery fully charged(1.265 specific gravity) to prevent battery damagewhen the temperature is below 0°C (32°F).1. Remove the battery from the chassis; refer toRemoving the Battery (page 36).2. Check the electrolyte level.3. Ensure that the filler caps are installed on thebattery.4. Charge the battery for 1 hour at 25 to 30 A or 6hours at 4 to 6 A.5. When the battery is fully charged, unplug thecharger from the electrical outlet, and disconnectthe charger leads from the battery posts (Figure48).6. Install the battery onto the machine and connectthe battery cables; refer to Installing the Battery(page 37).Note: Do not run the machine with the batterydisconnected; electrical damage may occur.g000538Figure 481. Positive battery post 3. Red (+) charger lead2. Negative battery post 4. Black (-) charger leadServicing the FusesThe electrical system is protected by fuses andrequires no maintenance. If a fuse blows, check thecomponent or circuit for a malfunction or short.1. Release the cushion from the rear of themachine.2. Pull out the fuse to remove or replace it (Figure49).3. Install the cushion to the rear of the machine.Note: Ensure that the correct-size fuse isinstalled Figure 49.g032693Figure 491. Ignition fuse—15 A 3. Power takeoff (PTO)fuse—10 A2. Accessory-port fuse—15A4. Infocenter fuse—7.5 A38 |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved