Form No. 3378-422 Rev AJackstand KitMulti Pro WM Turf SprayerModel No. 41216Installation InstructionsInstallationWARNINGCALIFORNIAProposition 65 WarningThis product contains a chemical or chemicalsknown to the State of California to cause cancer,birth defects, or reproductive harm.Note: Ensure that the booms are in the transport positionbefore installing this kit.1. Disconnect the boom hydraulics and connect the bedlift hoses; refer to your sprayer and Workman Operator’sManual.2. Disconnect the PTO driveshaft from the Workman;refer to your PTO kit Installation Instructions.3. Disconnect the sprayer fuse block from the Workmanfuse block; refer to your sprayer’s Operator’s Manual.4. Disconnect the control console from the Workmanand mount it to the tank storage bracket.5. Mount the jack stand legs to the machine as shown inFigure 1.6. Remove the bolts from the hold-down brackets; referto your sprayer’s Operator’s Manual.7. Disconnect the sprayer harness lead from the battery.8. Connect the jacks to the rear jack stands (Figure 1).Note: Discard the jack collar insert.9. Tilt the tank skid back until the rear jack stands touchthe ground.10. Attach the front jack stand extensions (Figure 1) andlower the tank skid until they touch the ground.Note: If the jack stand feet are not all level on theground, adjust the rear jacks until they are.11. Disconnect the sprayer’s speed sensor and connectthe Workman speed sensor; refer to your sprayer’sOperator’s Manual.12. Release the hydraulic cylinder pressure.13. Remove the lift cylinder pins and retract the liftcylinders; refer to your sprayer’s Operator Manual..14. Adjust the jack stands using the jacks until the backtank skid pins are loose and can be removed; refer toyour sprayer’s Operator’s Manual.15. Slowly drive the Workman out from under the sprayertank.Note: When mounting a sprayer that is elevated onjack stands, push the Workman under the sprayer.Don’t reverse under the tank.© 2013—The Toro® Company8111 Lyndale Avenue SouthBloomington, MN 55420Register at www.Toro.com. Original Instructions (EN)Printed in the USAAll Rights Reserved *3378-422* A