Figure 141. Screws2. Remove and discard the old scraper.3. Install the new scraper, and fasten it securely with the 4screws that you previously removed.Replacing the Rotor1. Remove the screws that secure the right side plate to themachine frame (Figure 15).Figure 152. Remove the rotor pin (Figure 16).Figure 161. Rotor pin3. Remove the old rotor.4. Install the new rotor by inserting the end of the rotor onto thefitted end in the housing and rotating the rotor until it snapsinto place (Figure 17).Figure 171. Fitted end of the rotorNote: Ensure that the nut that secures the rotor pin remainsinside the recessed hole in the right inside wall of thehousing.Note: The housing will flex when you install the rotor.5. Tighten the bolt on the side of the housing.6. Install the right side plate with the screws that you removedin step 1.ServiceToro has designed this machine to give you years of trouble-freeuse. Should it need service, bring the machine to an AuthorizedToro Service Dealer, who is specially trained to repair Toroproducts and will ensure that your Toro stays “all” Toro.Double-insulated AppliancesIn a double-insulated appliance, two systems of insulationare provided instead of grounding. No grounding means isprovided on a double-insulated appliance, nor should a means forgrounding be added to the appliance. Servicing a double-insulatedappliance requires extreme care and knowledge of the system,and should be done only by the qualified service personnel atan Authorized Toro Service Dealer. Replacement parts for adouble-insulated appliance must be identical to the parts theyreplace. A double-insulated appliance is marked with the words“Double Insulation” or “Double Insulated.” The symbol (squarewithin a square) may also be marked on the appliance.Product InformationA model and serial number decal is located on the housing.Always refer to specific numbers on the decal in correspondenceor when you need replacement parts.ServiceToro has designed this machine to give you years of trouble-freeuse. Should it need service, bring the machine to an Authorized9