Toro 38302 Operator's Manual

Also see for 1800 Power Curve: Parts catalog Operator's manual Operator's manual Operator's manual Operator's manual

Contents

OperationProduct OverviewFigure 81. Rotor blades 8. Power control bar2. Belt cover (not shown) 9. Upper handle3. Chute deflector 10. Cord4. Chute deflector trigger 11. Chute control rod5. Discharge chute handle 12. Handle knobs6. Cord guide 13. Discharge chute7. Interlock buttonImportant: This machine is intended for outdoor, residentialuse only. Do not use it indoors or for commercial or industrialpurposes.Connecting to a Power SourceTo reduce the risk of electric shock, this machine has a polarizedplug (i.e., one blade is wider than the other). Use only apolarized plug, UL-listed (CSA certified in Canada) extensioncord recommended for outdoor use. A polarized plug will fit in apolarized cord only one way. If the plug does not fit fully in thecord, reverse the cord. If it still does not fit, purchase a polarizedextension cord. If you have a polarized extension cord and theextension cord plug does not fit fully into the wall receptacle,reverse the plug. If it still does not fit, contact a qualified electricianto install the proper outlet. Do not change the machine orextension cord plug in any way.DANGERContact with water while operating the machine couldcause electric shock, causing injury or death.• Don't handle the plug or the machine with wethands or while standing in water.• Use only an extension cord recommended foroutdoor cold-weather use.Extension Cord Length Minimum Wire Gauge(A.W.G.)100 feet 14150 feet 12Note: Do not use an extension cord over 150 feet.Important: Check the extension cord frequently during usefor holes or cracks in the insulation. Do not use a damagedcord. Do not run the cord through standing water or wetgrass.Note: To prevent the extension cord from disconnecting duringoperation, use the cord lock on the upper handle before youconnect it to the machine (Figure 9).Figure 91. Cord lock 2. Extension cordWARNINGA damaged appliance cord can cause a shock or fire.Thoroughly inspect the appliance cord before usingthe machine. If the cord is damaged, do not operate themachine. The supply cord or switch of this equipmentcannot be replaced, and the equipment shall bescrapped.6