LubricationGreasing the Bearings andBushingsService Interval: Before each use or daily—Lubricatecastor arm bushings.Every 50 hours—Lubricate all greasefittings.The machine has grease fittings that must be lubricatedregularly with No. 2 General Purpose Lithium BaseGrease. If the machine is operated under normalconditions, lubricate all bearings and bushings afterevery 50 hours of operation or immediately after everywashing.Note: The castor fork shaft bushings must belubricated before each use or dailyThe grease fitting locations and quantities are:Traction Unit• Impact arms (2) (Figure 49)• Front Deck Lift cylinder pivots (2) (Figure 49)• Side Deck Lift cylinder pivots (2) (Figure 49)• Steering cylinder ball joints (4) (Figure 50)• Tie rod ball joints (2) (Figure 50)• King pin bushings (2) (Figure 50)• Rear axle pivot bushing (1) (Figure 51)• Brake shaft pivot bearings (1) (Figure 52)Figure 4943
