Menu
Toro 31102 Installation Instructions Manual
                |
g025299Figure 231. Transmission connectors 2. Wire harness connectors7. Route the wire harness to the transmission and plug the2 mating wire harness connectors into the unpluggedconnectors (Figure 23).8. Route the remaining length of wire harness to the leftside of the machine, under the floor and toward thefront of the machine.9. Plug the harness connector into the harness on thefront center of the deck.10. Secure the harness to the existing harness with tiewraps, and secure any excess harness away from anyhot, sharp, or moving parts.11. Plug the shunt wire harness into the deck wire harnessas shown in figure .Note: Use the shunt wire harness only when the decksare removed from the machine.g206087Figure 241. Shunt wire harnessInstalling the Step1. Using the 3 existing fender-mounting holes, secure thefront of the step to the machine with the 3 self-tappingscrews previously removed (Figure 25).g025300Figure 251. Step2. Using the rear of the step as a template, locate, mark,and drill 2 holes—8.3 mm (0.328 inch) diameter—inthe frame of the machine.3. Mount the rear of the step to the machine with 2screws (5/16 x 7/8 inch) and 2 flange nuts (5/16); referto Figure 25.13 |
Related manuals for Toro 31102
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved