Toro 23510 Operator's Manual

Cleaning under the Belt CoverService Interval: Every 50 hours1. Stop the engine and wait for all moving parts to stop.2. Disconnect the wire from the spark plug.3. Remove and retain the 4 bolts, lock washers, and 2spacers securing the belt cover to the left side of themachine.4. Remove the cover, and brush out all the debris aroundthe belt area.5. Install the belt cover, and tighten all the hardware.6. Connect the wire to the spark plug.Cleaning the Seed Gate1. Stop the engine and wait for all moving parts to stop.2. Disconnect the wire from the spark plug.3. Drain the fuel from the fuel tank; refer to Emptyingthe Fuel Tank (page 22).4. Tilt the machine rearward until the upper handlerests on the ground, and place a jack stand under themachine.Note: If necessary, use 2 people to tilt the machinerearward.5. Clean the debris between the frame and the seed gate.6. Lubricate the sliding surface between the frame andseed gate with a dry lubricant.7. Return the machine to the upright position.8. Fill the fuel tank.9. Connect the wire to the spark plug.28