Toro 22303 Operator's Manual

Also see for 22303: Service manual Operator's manual Operator's manual

207. Install the cylinder locks over the hydraulic hoses andsecure them with the clevis pins and cotter pins (Fig.17).m–4601213 412Figure 171. Hydraulic hoses2. Cylinder locks3. Hairpin cotter4. Clevis pinInstalling and RemovingAttachmentsConnecting an AttachmentImportant Use only Toro-approved attachments.Attachments can change the stability and the operatingcharacteristics of the traction unit. The warranty of thetraction unit may be voided if used with unapprovedattachments.Important Before installing the attachment, ensurethat the mount plates are free of any dirt or debris and thatthe pins rotate freely. If the pins do not rotate freely,grease them; refer to Greasing the Traction Unit, page 23.1. Position the attachment on a level surface with enoughspace behind it to accommodate the traction unit.2. Start the engine.3. Tilt the attachment mount plate forward.4. Position mount plate into the upper lip of theattachment receiver plate (Fig. 18).m–405512Figure 181. Mount plate 2. Receiver plate5. Raise the loader arms while tilting back the mountplate at the same time.Important The attachment should be raised enoughto clear the ground, and the mount plate should betilted all the way back.6. Stop the engine.7. Engage the quick attach pins, ensuring that they arefully seated in the mount plate (Fig. 19).Important If the pins do not rotate to the engagedposition, the mount plate is not fully aligned with theholes in the attachment receiver plate. Check the receiverplate and clean it if necessary.m–5919132Figure 191. Quick attach pins (shownin engaged position)2. Disengaged position3. Engaged positionIf you do not fully seat the quick attach pinsthrough the attachment mount plate, theattachment could fall off of the traction unit,crushing you or bystanders.Ensure that your quick attach pins are fullyseated in the attachment mount plate.Warning1. Position the attachment on a level surface with enoughspace behind it to accommodate the traction unit.2. Move the pump control lever to the turtle position.