Toro 2024 Operator's Manual

Also see for 2024: Operator's manual Software guide

Figure 351. Upper pins 2. Lower pins3. Place a block at the front and rear of the trailer and/ortruck tires.4. Using the drive pendant, set the engine speed to slow,and the drive speed to slow.5. Using the drive pendant, carefully drive the machineforward or rearward up the ramp and into position onthe trailer.6. Lower the stake-down plate to the deck of the trailer.7. Turn off the engine.8. Use appropriately rated chains and binders to securethe rings on the left and right track frames and thestake-down plate to the trailer (Figure 36).Figure 361. Tie-down points (only right side shown)9. Measure the distance from the ground to the highestpoint on the machine for reference to ensure that youdo not collide with low hanging obstacles.10. Remove the block from the trailer tires, and stow themwith the machine for use when unloading it.11. After driving a few miles, pull over and check to ensurethat all chains are still tight and that the machine hasnot moved.To unload the machine, reverse the above procedure.44