Toro 112-4881 Installation Instructions Manual

Form No. 3356-517 Rev AValve Update KitFor Model 22910 Vibratory Plow AttachmentsModel No. 112-4881Installation InstructionsImportant: If you intend to use a model 22910 vibratory plow with a TX 500 series tractionunit, you must first install this kit on the plow. Using a 22910 vibratory plow on a TX 500 seriestraction unit without this kit will cause major damage to the plow.InstallationLoose PartsUse the chart below to verify that all parts have been shipped.Step Description Qty. Use1 No parts required – Prepare the plow.Valve plate 1Bolt (5/16 x 1-1/4 inches) 2Bolt (5/16 x 3-1/2 inches) 3Thread locking compound (notsupplied) -Flange-head nut 5Lock washer 1Flow valve 12Clamp plate 1Install the ow valve.Hose, number 112-2766 1Hose, number 105-4333 1Hose, number 112-2768 1Hose, number 112-2769 1Elbow tting 3Straight tting 13T-tting 1Connect the hoses.© 2006—The Toro® Company8111 Lyndale Avenue SouthBloomington, MN 55420Register at www.Toro.com. Original Instructions (EN)Printed in the USA.All Rights Reserved

/ 4

Related manuals for Toro 112-4881