Toro 110-5076 Installation Instructions Manual

Form No. 3354-831 Rev AFootswitch Upgrade KitFor Multi-Pro 5600 Turf SprayerModel No. 110-5076Installation InstructionsInstallationLoose PartsUse the chart below to verify that all parts have been shipped.Step Description Qty. Use1 No parts required – Prepare the machine.2 No parts required – Remove the foot switch.Floor switch 1Wiring harness 1Hex-head screw (1/4 inch) 2Lock washer (1/4 inch) 2Nut (1/4 inch) 23Wire tie 4Install the oor switch.Step1Preparing the MachineNo Parts RequiredProcedure1. Park the sprayer on a flat surface, lower thebooms, set the parking brake, stop the engine,and remove the key.2. Disconnect battery negative cable.Step2Removing the Foot SwitchNo Parts RequiredProcedure1. Disconnect Sprayer Foot Switch connectorunder floor pan.2. Remove the retaining nut and remove thesprayer foot switch from the floor pan. Discardthe foot switch.3. Remove the bolt securing the left side ofthe front hood to the floor pan to allow theexisting floor switch wiring to be broughtabove the floor pan (Figure 1).© 2005—The Toro® Company8111 Lyndale Avenue SouthBloomington, MN 55420Register at www.Toro.com. Original Instructions (EN)Printed in the USA.All Rights Reserved

/ 4

Related manuals for Toro 110-5076