1All Rights ReservedPrinted in the USA 2003 by The Toro Company8111 Lyndale Avenue SouthBloomington, MN 55420-1196Rail Ramp Conversion KitFor Trans Pro 100Model No. 04246Form No. 3328–621Installation Instructions1. Secure tube assembly mounting brackets to squareholes in each side of trailer with (4) carriage bolts, flatwashers and locknuts (Fig. 1). Position tube assembliesso small cross tubes are to the rear.Note: On trailers with serial numbers prior to 220000001,all tube assembly mounting holes are not in sides of trailerand will have to mounted as follows:• Secure upper rear hole in tube assembly mountingbracket to top rear square hole in side of trailer.• Position tube assembly so it is parallel to top of trailer.• Using tube assembly mounting brackets as templates,locate, mark and drill (3) .390” dia. holes in side oftrailer.• Secure tube assembly mounting brackets to side oftrailer with (3) 3/8–16 x 3/4” capscrews (in place ofcarriage bolts), flat washers and locknuts.• Repeat procedure on opposite side of trailer.2. Mount a load ramp to the rear of each tube assemblywith a 3/6–16 x 2–1/2” lg. capscrew, spacer, washerand locknut (Fig. 1).1 234657Figure 11. Tube assembly2. Cross tube3. Locking bracket4. Load ramp5. Wheel rod6. Spacer7. Trailer stop3. Position a locking bracket onto each side of ramp sothey align with underside of load ramps, engage withcoated pins in load ramps and aligns with holes inramp (Fig. 1 & 3). Only one set of mounting holes isused per locking bracket.4. Loosely mount each locking bracket to ramp with5/16–18 x 3/4” lg. flange head screws and flange nuts(Fig. 1 & 3).Note: If ramp handle interferes with mounting fastener oflocking bracket, grind off end of handle to expose hole, asrequired (Fig. 2). Touch up paint.

Toro 04246 Installation Instructions Manual

Product

Learn More

Legal