Menu
Toro 07052 Operator's Manual
Also see for RAKE-O-VAC 07050: Operator's manualOperator's manual
                                | |
Contents
|
212. Insert clutch adjusting plates onto clutch handle.3. Position adjusting plates on clutch handle so distancebetween center of square hole in plates and center ofclutch lever pivot shaft is 12 inches. Tighten fastenerssecuring adjusting plates to clutch lever.132412.00”Figure 311. Clutch lever2. Clutch lever pivot shaft3. Clutch adjusting plates4. Clutch cover plate4. Insert torque wrench into square holes in adjustingplates and check to make sure torque is 45–50 pounds.5. Remove adjusting plates and store in a memorableplace.To adjust clutch proceed as follows:1. Remove clutch cover plate.2. Loosen clutch locking tab.3. Turn adjusting ring clockwise until proper adjustment isattained.4. Tighten clutch locking tab.5. Insert torque wrench into square holes in adjustingplates and check to make sure torque is 45–50 pounds.6. Install cover plate.Do not operate P.T.O. with clutch cover plateremoved as rotating parts can cause injury.WarningChanging Rubber FlapReplace rubber flap when it becomes worn or damaged.Change rubber flap on a flat, level surface andblock wheels to prevent sweeper from rolling.Failure to do so may result in personal injury.Caution1. Remove (10) capscrews, washers, and nuts mountingflap and flap retainer.12Figure 321. Rubber flap 2. Flap retainer2. Replace with new rubber flap and fasten securely.Cleaning Blower HousingBefore removing any debris from blower housing,disengage clutch, disengage P.T.O. drive, stopengine(s) and make certain all moving parts havestopped or personal injury may occur.Warning |
Related manuals for Toro RAKE-O-VAC 07050
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved