Toro 04861 Operator's Manual

Also see for 04861: Diagnostic manual Service manual Service manual Operator's manual

SafetyThis machine has been designed in accordancewith ANSI B71.4-2017, IEC 60335-1:2012, and IEC60335-2-29:2016 and meets these standards whenyou complete the setup instructions.General SafetyThis product is capable of amputating hands and feetand of throwing objects.• Read and understand the contents of thisOperator’s Manual before starting the machine.• Use your full attention while operating themachine. Do not engage in any activity thatcauses distractions; otherwise, injury or propertydamage may occur.• Do not put your hands or feet near movingcomponents of the machine.• Do not operate the machine without all guardsand other safety protective devices in place andfunctioning properly on the machine.• Keep bystanders and children out of the operatingarea. Never allow children to operate the machine.• Shut off the machine, remove the key (if equipped),and wait for all movement to stop before you leavethe operator’s position. Allow the machine to coolbefore adjusting, servicing, cleaning, or storing it.Improperly using or maintaining this machine canresult in injury. To reduce the potential for injury,comply with these safety instructions and alwayspay attention to the safety-alert symbol , whichmeans Caution, Warning, or Danger—personal safetyinstruction. Failure to comply with these instructionsmay result in personal injury or death.Safety and Instructional DecalsSafety decals and instructions are easily visible to the operator and are located near any areaof potential danger. Replace any decal that is damaged or missing.decal120-9570120-95701. Warning—stay away from moving parts, keep all guardsand shields in place.decal133-8061133-8061decal137-9712137-97121. Warning—read theOperator’s Manual.3. Explosion hazard—do notopen the battery; do notuse a damaged battery.2. Warning—keep attemperatures below 65° C(149° F).4. Warning—read theOperator’s Manualfor battery charginginformation.decal138-1644138-16441. Rotate the handle toengage.3. Transmission control2. With the machine in theNeutral position, rotate thehandle to disengage.4