Toro 03229 Installation Instructions Manual

Installing the Hydraulic Motor, Hub, and Rear WheelParts Required1 Hydraulic-motor assembly2 Hydraulic fitting4 Bolt (1/2 x 2-3/4 inches)4 Locknut (1/2 inch)1 Wheel-hub assembly4 Lug nut1 Locknut (1-1/2 inches)G4959061. Secure the hydraulic-motor assembly to thesteering fork with 4 bolts (1/2 x 2-3/4 inches)and 4 locknuts (1/2 inch) .2. While holding the bolts with a backing wrench,torque the locknuts to 70 to 84 N∙m (52 to 62ft-lb).G4959073. Lubricate the o-rings on the fittings with a lightcoating of oil.4. Install the 2 hydraulic fittings on the hydraulic-motor assembly. Orient the fittings as shown.Torque the fittings 134 to 164 N∙m (99 to 121ft-lb). Use a backing wrench to retain properorientation of the fittings while torquing them.3463-204A Page 3