Sony XCI-SX100C Technical Manual

Also see for xci-sx100: Operating instructions

Contents

Overview78 Hi-speed USB (USB 2.0) connectorYou can connect a USB mouse/keyboard via thisconnector to control a camera.9 SERIAL / Auto iris connector (6-pin)You can connect a serial cable to this connector tocontrol a camera from a camera-control device. Youcan connect a DC iris lens to control the lens froma camera.q; DC IN (DC power input) connector (12-pin)You can connect a camera cable (not supplied) tothis connector to input the +12 V DC power supply.* Delay can be controlled via strobe delay.qa MODE switchesFor service use. Both switches are set to the left sideas the factory setup.NoteIf either of these switches is set to the right side, thecamera will not start normally.qs RESET switchThis is a hardware reset switch. Push to restart thecamera.qd STATUS LEDLights in red when the BIOS is starting up.qf POWER LEDLights green when the power is on.qg LAN connectorYou can connect a LAN cable to this connector toinput/output a signal to/from the host device/thecamera.Notes• For safety, do not connect the connector for peripheraldevice wiring that might have excessive voltage to thisport.• When you connect the LAN cable of the unit toperipheral device, use a shielded-type cable to preventmalfunction due to radiation noise.Pin No. Signal Pin No. Signal1 VBUS 3 D+2 D- 4 GNDPin No. Signal Pin No. Signal1 TXD 4 IRIS_CONTROL–2 RXD 5 IRIS_CONTROL+3 GND 6 IRIS_DRIVE+Pin No. Signal Pin No. Signal1 GND 7 NC2 VCC 8 GND3 GND 9 VCC4NC10Exposure pulseoutput*(strobe output)5 GND 11 Trigger pulse input6 NC 12 GNDPin No. Signal Pin No. Signal1 TRD+ (0) 5 TRD– (2)2 TRD– (0) 6 TRD– (1)3 TRD+ (1) 7 TRD+ (3)4 TRD+ (2) 8 TRD– (3)