Sony XCI-SX100C Technical Manual

Also see for xci-sx100: Operating instructions

Contents

Overview4System ComponentsAn Intelligent Camera XCI-SX100/SX100C/V100/V100C system can include the following optional products.NoteThe DC-700 camera adapter is not recommended, as its power supply may become insufficient depending on the cameraoperation mode. Use a power supply that is at least 12 V, 2 A (24 VA).1 Intelligent CameraThis is a high-resolution camera equipped with aCCD and built-in x86-compatible CPU.2 CCXC-12P02N (2 m, 6.6 ft)/05N (5 m, 16.4 ft)/10N (10 m, 32.8 ft)/25N (25 m, 82 ft) cameracable (commercially available from Sony)This is attached to the DC IN connector of thecamera and is used for power supply and trigger-signal input/output.3 Lens (commercially available)Use a lens appropriate for the camera module andyour needs.NoteWhen using a CS mount lens, be sure to remove theC mount adaptor on the camera. In addition, aseparate 4-pin to 6-pin conversion cable is requiredwhen using a DC iris lens.4 Fall-prevention wire rope (supplied)This is attached to one of the auxiliary holes (top),using the supplied screw.NoteAlways use the fall-prevention wire rope to securethe camera when installing the camera to a ceiling.5 LAN cable (enhanced category 5) (commerciallyavailable)This is attached to the LAN connector of thecamera and is used to access a network.NoteDo not connect the LAN cable to a network whereexcess voltage is present.6 USB mouse/keyboard (commercially available)Use a mouse or keyboard that supports USB.NoteWhen using a USB device other than a mouse orkeyboard, make sure that the device is self-powered.7 CompactFlash (commercially available)Use a FixedDisk and Industrial type CompactFlash.NoteBe aware that malfunctions may occur if you use aremovable disk.1 2 34 5 6 7