Sony VG-C70AM Instruction & Operation Manual

Also see for VG-C70AM: Operating instructions Instruction & operation manual

JBRChttp://www.jbrc.net/hp/contents/index.htmlInfoLITHIUMDSLR-A700NP-FM500H 1 2NP-FM55H NP-FM50 NP-FM30 0 4012345 OPEN/CLOSE6 Fn7 C8910 ON/OFF  18 VG-C70AMEnglishBefore operating the product, please read this manual thoroughly and retain it forfuture reference.WARNINGTo reduce fire or shock hazard, do not expose the unit to rain or moisture.Tape over lithium battery contacts to avoid short-circuit when disposing of batteries,and follow local regulations for battery disposal.Keep batteries or things that could be swallowed away from young children. Contact adoctor immediately if an object is swallowed.Immediately remove the batteries and discontinue use if... the product is dropped or subjected to an impact in which the interior is exposed. the product emits a strange smell, heat, or smoke.Do not disassemble. Electric shock may occur if a high voltage circuit inside theproduct is touched.CAUTIONReplace the battery with the specified type only. Otherwise, fire or injury may result.Do not expose the batteries to excessive heat such as sunshine, fire or the like.This symbol is intended to alert the user to the presence of importantoperating and maintenance (servicing) instructions in the literatureaccompanying the appliance.For the Customers in the U.S.A.CAUTIONYou are cautioned that any changes or modifications not expressly approved in thismanual could void your authority to operate this equipment.NOTEThis equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses, and can radiate radiofrequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment offand on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:– Reorient or relocate the receiving antenna.– Increase the separation between the equipment and receiver.– Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.– Consult the dealer or an experienced radio/TV technician for help.What is the “InfoLITHIUM” ?The “InfoLITHIUM” is a lithium ion battery pack which can exchange data withcompatible electronic equipment about its battery consumption. Sony recommendsthat you use the “InfoLITHIUM” battery pack with electronic equipment having thelogo.Notes on UseThis unit is a Vertical Grip for DSLR-A700. Do not attach itto other devices.This unit is designed to be dust-and moisture-resistant butnot to be waterproof and splash-proof.Only one or two “InfoLITHIUM” battery pack(s) NP-FM500Hcan be used.NP-FM55H, NP-FM50, NP-FM30 cannot be used. Remove the battery packs when storing this unit for an extended period of time.Leaving the battery packs inserted in the unit may cause the battery chamber to bedamaged because liquid can leak from a battery. If that should occur, take the unitimmediately to the nearest Sony dealer for repair. Be sure to use a genuine Sony battery pack with this unit. This unit does not have a battery charger function.Places to avoid for unit use and storageRegardless of whether this unit is in use or in storage, do not leave it where it can beexposed to: Extremely high temperaturesDo not leave this unit where it might be exposed to direct sunlight; Avoid placeslike vehicle dashboards or near heat sources. The inside of a vehicle can becomeextremely hot if the vehicle windows are closed in the summer or if the vehicle isunder direct sunlight. The unit can become deformed or experience malfunctions ifleft inside a vehicle. Excessive vibrations Strong electromagnetism or rays Excessive sand or dustOther cautions This unit is designed for use from 0 °C to 40 °C (32 °F to 104 °F). A rapid and dramatic rise in temperature causes condensation to form. Therefore,seal the unit in a plastic bag and remove as much of the air inside of the bag asyou can before attempting to bring this unit inside after being in the cold for anyextended period of time. Once the temperature in the bag has had a change to risegradually to the temperature in the room, you can safely remove it from the bag.These procedures will prevent the unit from changing temperatures rapidly, andtherefore prevent condensation from forming. When dirty, this unit may be cleaned with a clean, dry cloth. Do not allow this unitto come in contact with alcohol or other chemicals. This unit has an electrically-connected signal contact point with the camera.If you load the battery pack(s) while this unit is not attached to the camera, the unitcould malfunction or be damaged by a shorting of the contact point.When attaching this unit to the camera, detaching this unit from the camera orstoring this unit separately, be sure to remove the battery pack(s) from this unit. Identifying the Parts1 Electrical contacts2 Guide bar3 Attachment screw4 Locating pin5 Battery chamber OPEN/CLOSE knob6 Recording: Fn buttonPlayback: (Rotate) button7 Recording: C (Custom) buttonPlayback: (Histogram) button8 Multi selector9 Rear control dial10 Grip control ON/OFF switch11 (Exposure) buttonOwner’s RecordThe model and serial numbers are located inside of the unit.Record the serial number in the space provided below.Refer to them whenever you call upon your Sony dealer regarding this product.Model No. VG-C70AM Serial No.Printed on 70% or more rectcled paperusing VOC (Volatile Organic Compound)-free vegetable oil based ink.1112 AF/MF13 AEL AE14151617181920211 POWER OFF23 4 5  NP-FM500H 1 2 NP-FM55H NP-FM50 NP-FM301 POWER OFF2 OPEN/CLOSE OPEN3 45  1  NP-FM500H 267 OPEN/CLOSE CLOSEON/OFF ON ON/OFFON/OFF ON/OFF ON/OFF POWERON/OFF ON/OFFNP-FM500H 22 70-200mm F2.8G 300mm F2.8G 70-200mm F2.8G DMF 5.5 mm5.5 mmPOWERON POWER OFF POWER OFFNP-FM500H DC7.2VNP-FM500H 2 1,300 CIPA DSLR-A700137.7 mm 121.5 mm 87.2 mm( )285 g )0 401 1 1InfoLITHIUM12141312113456 7 8 9 101516 17181 24 56 7313 4521912 Recording: AF/MF (Auto focus/Manual focus) buttonPlayback: (Close focus) button13 Recording: AEL (AE lock) buttonPlayback: (Index) button14 Camera battery cover slot15 Strap hook16 Shutter button17 Front control dial18 Tripod receptacle19 Grip censor20 Battery pack stopper21 Battery pack tray Attaching this unit to the camera1 Set the POWER switch of the camera to “OFF.” If the battery pack(s) is in this unit, remove the battery pack(s) from this unit.2 Remove the battery pack from the camera.3 Remove the terminal cover of this unit’s electrical contacts. After use, put the terminal cover back on to protect the electrical contacts.4 Align the following part to attach this unit to the camera.[This unit] Guide bar  [Camera] Battery chamber[This unit] Camera battery cover slot  [Camera]Battery chamber door[This unit] Attachment screw  [Camera] Tripod receptacle[This unit] Locating pin  [Camera] The hole on the bottom5 Rotate the attachment screw to lock it. Periodically confirm that the attachment screw is not loose while in use. Inserting the battery packsBattery pack NP-FM500H (1 or 2 required) NP-FM55H, NP-FM50, NP-FM30 are not available with this unit. Be sure to charge the battery packs with the specified battery adaptor before use.1 When replacing the battery packs with this unit attached to thecamera, set the POWER switch of the camera to OFF.2 Rotate the battery chamber OPEN/CLOSE knob to “OPEN.”3 Press up the battery pack stopper with your finger as illustrated. When releasing the lock of the battery pack stopper, be careful to pop up thebattery pack tray.4 Remove the battery pack tray.5 Attach the battery packs to the battery tray according to thedisplay on the battery tray. When attaching a battery pack, attach it to either side. Do not touch the terminal of the battery pack tray . Attach the battery pack NP-FM500H only to the battery pack tray. Do not attachthe other battery packs. Do not disassemble the battery pack tray. When inserting two battery packs, start by using the one that has less power.When the battery capacity of the used battery pack runs out, the unit willautomatically switch to the other battery pack.6 Insert the battery pack tray into the original position by pressingit until it clicks. Make sure that the battery pack stopper locks the battery pack tray.7 Close the battery chamber door and rotate the battery chamberOPEN/CLOSE knob to “CLOSE” to close the cover. Rotate the battery chamber OPEN/CLOSE knob properly to the position asillustrated and close the cover.Shooting vertical imagesThe operations of the unit’s dials and buttons are same as those for the camera mainbody.When using this unit in vertical orientation, set the grip control ON/OFF switch to“ON.” The grip control ON/OFF switch switches the dial and button functions ON andOFF. Regardless of the position of the grip control ON/OFF switch, the camera operatingbutton always operates. Switch the power ON and OFF with the POWER switch of the camera. The gripcontrol ON/OFF switch can not switch the power ON and OFF.Remaining battery power indicatorWhen inserting the two battery packs, the following indicator will be displayed on theLCD screen of the camera.Of the two battery packs, use the one that has less power first.When doing so, the mark of the battery pack in use is bright and the mark of the otherbattery pack is dark. The remaining battery level of the battery pack in use is displayedas a percentage (%).The mark of the battery pack in use changes as shown below. When the power ofbattery in use runs out, the unit automatically switches to the other battery pack.Remainingbattery capacity high lowIf images are still being shot for a short time after the mark appears, thepower of that battery will run out, but the unit will automatically switch to theother battery pack.Notes relating to the lens When using this unit attached to the camera with the 70-200mm F2.8 G or 300mmF2.8 G lens attached to the tripod-mounting collar, rotate tripod-mounting collarto the position that allows the grip to be used. When using this unit attached to the camera with 70-200mm F2.8 G lens attachedto the tripod-mounting collar, the following lens switches may not operate at thevertical shooting. Before vertical shooting, set them at the horizontal position. Focus-mode switch DMF-mode switch Focus-range limiter When using a tripod, use one screw that is 5.5 mm or shorter. This unit cannot befirmly fastened on a tripod using long screws. Attempting to do so will damage thisunit.TroubleshootingSymptom RemedyThe camera does not work even after theunit is attached to the camera, the batterypack(s) are inserted into the unit and thecamera POWER switch is set to ON. Check that the unit attachment screwis securely tightened. Check that the battery pack(s) arecharged. Reattach the battery pack tray to theunit.Shutter button or other operatingbuttons do not work. Reattach the battery pack tray to theunit. Set the camera POWER switch toOFF, remove the battery pack(s), andreattach the unit to the camera.“For “InfoLITHIUM” battery only” isdisplayed even though genuine Sonybattery pack(s) are being used. Reattach the battery pack tray to theunit. Set the camera POWER switch toOFF, remove the battery pack(s), andreattach the unit to the camera.SpecificationsBattery pack NP-FM500H DC7.2VRecording performanceWith two NP-FM500H battery packs:Approx. 1,300 frames The measuring method conforms to CIPA standard. Depending on the condition of use, recording performance may be lower lessthan what was listed. For details, refer to the operating instructions supplied with DSLR-A700.Dimensions Approx. 137.7 mm × 121.5 mm × 87.2 mm (w/h/d)(5.42 in. × 4.78 in. × 3.43 in.)Mass Approx. 285 g (10.1 oz)(including the battery tray, excluding the battery packs)Operating temperature 0°C to 40°C (32°F to 104°F)Included items Vertical grip (1), Battery tray (1), Terminal cover (1),Set of printed documentationDesign and specifications are subject to change without notice.and “InfoLITHIUM” are trademarks of Sony Corporation.2021/ Operating Instructions /Mode d’emploi / Manual de instruccionesVG-C70AMVertical GripPoignée verticale© 2007 Sony Corporation Printed in Japan3-277-674-04 (1)

/ 2

Related manuals for Sony VG-C70AM