Sony SRS-X2 Reference Manual

Also see for SRS-X2: Quick start guide Quick start guide Installation manual Quick start guide Quick start guide

English Personal Audio SystemBefore operating the system, please read this guide thoroughly and retain it for future reference.WARNINGTo reduce the risk of fire or electric shock, do not expose this apparatus to rain ormoisture.To reduce the risk of fire, do not cover the ventilation of the apparatus with newspapers,tablecloths, curtains, etc. And do not place lighted candles on the apparatus.To reduce the risk of fire or electric shock, do not expose this apparatus to dripping or splashing,and do not place objects filled with liquids, such as vases, on the apparatus.Do not install the appliance in a confined space, such as a bookcase or built-in cabinet.Do not expose the batteries (battery pack or batteries installed) to excessive heat such as sunshine,fire or the like for a long time.As the main plug of the USB AC adaptor is used to disconnect the USB AC adaptor from the mains,connect it to an easily accessible AC outlet. Should you notice an abnormality in it, disconnect itfrom AC outlet immediately.The unit is not disconnected from the AC power source (mains) as long as it is connected to the walloutlet, even if the unit itself has been turned off.PrecautionsNote when using with a mobile phoneˎˎ For details on operation of your mobile phone when receiving a telephone call while transmittingthe sound using the BlUeTooTh connection, refer to the operating instructions supplied with themobile phone.On safetyThe nameplate and important information concerning safety are located on the bottom exterior ofthe main unit and on the surface of the USB AC adaptor.ˎˎ Before operating the system, be sure that the operating voltage of the system is identical withthat of your local power supply.Where purchased Operating voltageAll countries/regions 100 V – 240 V AC, 50 hz/60 hzNotes on the USB AC adaptorˎˎ When connecting or disconnecting the USB AC adaptor, turn off the system beforehand.otherwise, it may cause malfunction.ˎˎ Use only the supplied USB AC adaptor. To avoid damaging the system, do not use any other USBAC adaptor.ˎˎ Plug the USB AC adaptor into a nearby wall outlet (mains). In the case of a problem, unplug itfrom the wall outlet (mains) immediately.ˎˎ Do not install the USB AC adaptor in a confined space, such as a bookcase or built-in cabinet.ˎˎ To reduce the risk of fire or electric shock, do not expose the USB AC adaptor to dripping orsplashing, and do not place objects filled with liquids, such as vases, on the USB AC adaptor.On placementˎˎ Do not set the speaker in an inclined position.ˎˎ Do not leave the system in a location near heat sources, or in a place subject to direct sunlight,excessive dust, moisture, rain or mechanical shock.On operationˎˎ Do not insert any small objects, etc., into the jacks of the system. The system may short out ormalfunction.On cleaningˎˎ Clean this system with a soft cloth slightly moistened with a mild detergent solution. Do not usealcohol, benzine, or thinner to clean the cabinet.Othersˎˎ even if you do not intend to use the unit for a long time, charge the battery to its full capacityonce every 6 months to maintain its performance.ˎˎ If you have any questions or problems concerning this system that are not covered in thismanual, please consult your nearest Sony dealer.On Copyrightsˎˎ The BlUeTooTh® word mark and logos are owned by the Bluetooth SIG, Inc. and any use of suchmarks by Sony Corporation is under license.ˎˎ The N Mark is a trademark or registered trademark of NFC Forum, Inc. in the United States and inother countries.ˎˎ other trademarks and trade names are those of their respective owners.What is BlUETOOTh wireless technology?BlUeTooTh wireless technology is a short-range wireless technology that enables wireless datacommunication between digital devices, such as a computer and digital camera. BlUeTooThwireless technology operates within a range of about 10 m.Connecting two devices as necessary is common, but some devices can be connected to multipledevices at the same time.You do not need to use a cable for connection, nor is it necessary for the devices to face oneanother, such is the case with infrared technology. For example, you can use such a device in a bagor pocket.BlUeTooTh standard is an international standard supported by thousands of companies all overthe world, and employed by various companies worldwide.Maximum communication rangeMaximum communication range may shorten under the following conditions.ˋ There is an obstacle such as a person, metal, or wall between the system and BlUeTooThdevice.ˋ A wireless lAN device is in use near the system.ˋ A microwave oven is in use near the system.ˋ A device that generates electromagnetic radiation is in use near the system.Interference from other devicesBecause BlUeTooTh devices and wireless lAN (Ieee802.11b/g) use the same frequency, microwaveinterference may occur and resulting in communication speed deterioration, noise, or invalidconnection if the system is used near a wireless lAN device. In such a case, perform the following.ˋ Use the system at least 10 m away from the wireless lAN device.ˋ If the system is used within 10 m of a wireless lAN device, turn off the wireless lAN device.Interference to other devicesMicrowaves emitting from a BlUeTooTh device may affect the operation of electronic medicaldevices. Turn off the system and other BlUeTooTh devices in the following locations, as it maycause an accident.ˋ where inflammable gas is present, in a hospital, train, airplane, or a gas stationˋ near automatic doors or a fire alarmNotesˎˎ To be able to use the BlUeTooTh function, the BlUeTooTh device to be connected requires thesame profile as the system’s.Note also that even if the same profile exists, devices may vary in function depending on theirspecifications.ˎˎ Due to the characteristic of BlUeTooTh wireless technology, the sound played on the system isslightly delayed from the sound played on the BlUeTooTh device during talking on thetelephone or listening to the music.ˎˎ This system supports security capabilities that comply with the BlUeTooTh standard to provide asecure connection when the BlUeTooTh wireless technology is used, but security may not beenough depending on the setting. Be careful when communicating using BlUeTooTh wirelesstechnology.ˎˎ We do not take any responsibility for the leakage of information during BlUeTooThcommunication.ˎˎ A device featuring the BlUeTooTh function is required to conform to the BlUeTooTh standardspecified by Bluetooth SIG, and be authenticated. even if the connected device conforms to theabove mentioned BlUeTooTh standard, some devices may not be connected or work correctly,depending on the features or specifications of the device.ˎˎ Noise or sound skips may occur depending on the BlUeTooTh device connected with thesystem, the communication environment or the usage environment.SpecificationsSpeaker sectionSpeaker system Approx. 45 mm dia. × 2enclosure type Bass reflexAmplifier sectionMaximum output powerUsing USB AC adaptor and battery: 10 W + 10 WUsing battery only: 5 W + 5 W(at 10 % harmonic distortion,1 khz, 8 Ω)BlUETOOThCommunication SystemBlUeTooTh Specification version 3.0output BlUeTooTh Specification Power Class 2Maximum communication rangeline of sight approx. 10 m*1Frequency band 2.4 Ghz band (2.4000 Ghz - 2.4835 Ghz)Modulation method FhSSCompatible BlUeTooTh Profiles*2A2DP (Advanced Audio Distribution Profile)AVRCP (Audio Video Remote Control Profile)hSP (headset Profile)hFP (hands-free Profile)Supported Codec* 3 SBC*4Transmission range (A2DP)20 hz - 20,000 hz (Sampling frequency 44.1 khz)* 1 The actual range will vary depending on factors such as obstacles between devices, magneticfields around a microwave oven, static electricity, reception sensitivity, aerial’s performance,operating system, software application, etc.*2 BlUeTooTh standard profiles indicate the purpose of BlUeTooTh communication betweendevices.*3 Codec: Audio signal compression and conversion format*4 Subband CodecMicrophoneType electret condenserDirectional characteristicomni directionaleffective frequency range200 hz - 4,000 hzGeneralInput AUDIo IN jack (ø 3.5 mm stereo mini jack)Power DC 5 V 1.5 A (using the supplied USB AC adaptor connected to AC 100 V - 240V, 50 hz/60 hz, 0.3 A power supply) or, using built-in lithium-ion batteryUsage life of lithium-ion battery (using the BlUeTooTh connection)approx. 5 hours*5Dimensions (including projecting parts and controls)Approx. 171 mm × 60.5 mm × 56.5 mm (w/h/d)Mass Approx. 500 g including batterySupplied accessoriesUSB AC adaptor (AC-S5V15AS)*6 (1)Carrying pouch (1)Quick Start Guide (1)Reference Guide (this document) (1)Warranty Card (1)* 5 Time may vary, depending on the temperature or conditions of use.*6 Use only the supplied USB AC adaptor. The system is not guaranteed to work with any other USBAC adaptor.Design and specifications are subject to change without notice.Personal Audio SystemSistema de Áudio PessoalReference GuideGuia de ReferênciaSRS-X2©2015 Sony CorporationPrinted in ChinaImpresso na Chinahttp://www.sony.net/4-540-488-51(1)evite contato com a água. este produto não é à prova d’água.

/ 2

Related manuals for Sony SRS-X2