24 ConnectionsChapter 2 PreparationsConnecting the Controller (BKM-16R)1 Turn off the MAIN POWER switch of the monitorbefore connecting the units.2 Set the NETWORK switches of the monitor and thecontroller to PEER TO PEER.3 Connect the LAN (10/100) connector of the monitorand the LAN (10/100) connector of the controller byusing the SMF-700 or the cable supplied with theBKM-37H/BKM-38H, or a 10BASE-T/100BASE-TXstraight LAN cable (shielded-type, optional).When an optional LAN cable is connected, use ashielded-type cable to prevent a malfunction due tonoises.4 Connect the DC 5V OUT connector of the monitor andthe DC 5V/12V IN connector of the controller by usingthe SMF-700 or the cable supplied with the BKM-37H/BKM-38H.Or connect the output cable of the AC adaptor suppliedwith the controller to the DC 5V/12V IN connector ofthe controller.Connecting the Multiple Units withthe LANThe controller controls up to 32 monitors. Up to fourcontrollers are connected to one monitor in single mode.The controller cannot control monitors in anothersubnetwork.NoteLAN PEER TO PEERNETWORKLANPEER TOPEERNETWORKController(BKM-16R)LAN (10/100) connectorDC 5V OUTconnectorDC 5V/12V INconnectorLAN (10/100)connectorSet to PEER TOPEER.SMF-700, etc.Set to PEER TO PEER.MonitorNote
