PEGA-MD700Sony Corporation © 2001 Printed in Taiwan 4-656-604-01(1)NOTEThis equipment has been tested and found to comply with thelimits for a Class B digital device, pursuant to Part 15 of theFCC Rules. These limits are designed to provide reasonableprotection against harmful interference in a residentialinstallation. This equipment generates, uses, and can radiateradio frequency energy and, if not installed and used inaccordance with the instructions, may cause harmfulinterference to radio communications. However, there is noguarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interferenceto radio or television reception, which can be determined byrotating the equipment off and on, the user is encouraged totry to correct the interference using one or more of thefollowing measures:– Reorient or relocate the receiving antenna.– Increase the separation between the equipment andreceiver.– Connect the equipment into an outlet on a circuit differentfrom that to which the receiver is connected.– Consult the dealer or an experienced radio/TV technicianfor help.If you have question about this product, call the SonyCustomer Information Center at keep on next line 1-877-760-7669; or write to the Sony Customer Information Center at12451 Gateway Boulevard, Fort Myers, FL 33913. The numberbelow is for FCC-related matters only.Declaration of ConformityTrade Name: SONYModel No.: PEGA-MD700Responsible Party: Sony Electronics Inc.Address: 680 Kinderkamack Road, Oradell, NJ 07649 USATelephone No.: 201-930-6972This device complies with part 15 of the FCC Rules.Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received,including interference that may cause undesiredoperation.The supplied interface cable must be used with the equipmentin order to comply with the limits for a digital device pursuantto Subpart B of Part 15 of FCC Rules.WARNING! Caution: To reduce the risk of fire, use onlyNo. 26 AWG or larger telecommunicationline cord.