Sony KLV-V26A10E Service Manual

Also see for Bravia KLV-V26A10E: Service manual Operating instructions

– 21 –AT2XRM-EA001/RM-ED0011. Lay TV set flat and remove the rear cover (See 2-1.). Ensure screen is shielded from damage by laying on protective material.2. Disassemble the foot from the TV set by removing the four screws circled.3. Remove the main brackets (See 2-2.)4. Disconnect the harnesses connected to boards beneath the main shield case (NP1, BL and N boards). Remove the main shield case.5. Remove the NP1, BL and N boards (See 2-8.)6. Remove the A1board (KLV-V26A10E/KDL-V26A12U) or the A2 board (KLV-V32A10E/KDL-V32A12U) (See 2-4.)7. Re-fit the foot to the TV set and place the set back in a vertical position. Place a support of approx 35cm high as close as possibleto the TV set as shown below.8. Arrange the removed circuit boards as shown in the picture. Reconnect the interconnecting harnesses to the circuit boards.Note: Two new cables are needed to connect the boards in the service positionCable 1: Part Number: 9-948-020-73 G2 board CN6200, CN6203 to NP1 board CN5801, CN5802Cable 2: Part Number: 9-948-020-72 N board CN3402 to A1/A2 board CN51052-10.SERVICE POSITIONScrews35cm