106To remove the lens hoodLoosen the lens hood by turning it in theopposite direction of the arrow in theillustration above.• Remove the lens hood when you use the flash,Nightshot or SuperNightshot, or its shadow willappear in the picture.Remote CommanderA PHOTO button (24)The on-screen image when you press thisbutton will be recorded onto the “MemoryStick Duo” as a still image.B Memory control buttons (Index*, –/+,Memory playback) (29)C SEARCH M. button* (33)D . > (Previous/Next) buttons*(33)E Video control buttons (Rewind,Playback, Fast-forward, Pause, Stop,Slow) (28)F ZERO SET MEMORY button* (32)G TransmitterH START/STOP button (21, 23)I Power zoom buttons (25, 30)J DISPLAY button (18)* These buttons are not available during EasyHandycam operation.b Notes• Remove the insulation sheet before using theRemote Commander.• Aim the Remote Commander towards theremote sensor to operate your camcorder(p. 105).To change the battery of the RemoteCommander1 While pressing on the tab, inset yourfingernail into the slit to pull out the batterycase.2 Place a new battery with the + side facingup.3 Insert the battery case back into the RemoteCommander until it clicks.WARNINGBattery may explode if mistreated. Do notrecharge, disassemble or dispose of in fire.b Notes• When the lithium battery becomes weak, theoperating distance of the Remote Commandermay shorten, or the Remote Commander maynot function properly. In this case, replace thebattery with a Sony CR2025 lithium battery.Use of another battery may present a risk of fireor explosion.712345689q;Insulation sheetTabIdentifying parts and controls (Continued)