Sony HMI-3000MT Manual

Also see for HMI-3000MT: Instructions for use

183. The leakage current could increase when connected toother equipment.4. For this particular equipment, all accessory equipmentconnected as noted above, must be connected to mainsvia an additional isolation transformer conformingwith the construction requirements of IEC60601-1and providing at least Basic Insulation.5. This equipment generates, uses, and can radiate radiofrequency energy. If it is not installed and used inaccordance with the instruction manual, it may causeinterference to other equipment. If this unit causesinterference (which can be determined by unpluggingthe power cord from the unit), try these measures:Relocate the unit with respect to the susceptibleequipment. Plug this unit and the susceptibleequipment into different branch circuit.Consult your dealer. (According to standard IEC60601-1-2 and CISPR11, Class B, Group 1)Important EMC notices for use in themedical environments• The HMI-3000MT needs special precautions regardingEMC and needs to be installed and put into serviceaccording to the EMC information provided in thisinstructions for use.• The portable and mobile RF communicationsequipment such as cellular phones can affect theHMI-3000MT.WarningThe use of accessories and cables other than thosespecified, with the exception of replacement parts sold bySony Corporation, may result in increased emissions ordecreased immunity of the HMI-3000MT.WarningIf the HMI-3000MT should be used adjacent to or stackedwith other equipment, it should be observed to verifynormal operation in the configuration in which it will beused.List of cables used for EMC testType of cable SpecificationsHMO-CA50M : Head Mounted Display Cable 5 m, Shield cableGuidance and manufacturer’s declaration-electromagnetic emissionsThe HMI-3000MT is intended for use in the electromagnetic environment specified below.The customer or the user of the HMI-3000MT should assure that it is used in such an environment.Emission test Compliance Electromagnetic environment-guidanceRF emissionsCISPR 11 Group 1The HMI-3000MT uses RF energy only for its internalfunction. Therefore, its RF emissions are very low and arenot likely to cause any interference in nearby electronicequipment.RF emissionsCISPR 11Class BThe HMI-3000MT is suitable for use in all establishmentsother than domestic and those directly connected to thepublic low-voltage power supply network that suppliesbuildings used for domestic purposes.Harmonic emissionsIEC 61000-3-2Not applicableVoltage fluctuations/flicker emissionsIEC 61000-3-3Not applicable