1-6 HVR-15001-7. Installation Setup and Adjustment1-7-1. Front Panel SettingFront panel1. i.LINK INPUT SELECT button settingi.LINK : HDV: Video and audio signals in HDVformati.LINK : DV *: Video and audio signals in DVformati.LINK : DVCAM *: Video and audio signals inDVCAM format*: The display follows the recording format setting inthe REC FORMAT menu item. (Refer to theoperating instructions for details)2. VIDEO INPUT SELECT button settingCOMPOSITE: Composite video signal(When HVBK-1505 is attached)S VIDEO: S-video (separated Y and C)signals (When HVBK-1505 isattached)COMPONENT SD: Component video signals(When HVBK-1505 is attached)SDI: SDI video signalSG: Video test signal3. AUDIO INPUT SELECT button settingANALOG: Analog audio signal(When HVBK-1505 is attached)AES/EBU: Digital audio signal in AES/EBU formatSDI: Digital audio signal in SDIformatSG: Audio test signal4. AUDIO VARIABLE switch settingPRESET : Sets both the REC and PB levelsto the normal level.REC : Sets the REC audio level of thechannels respectively with theCH-1/2/3/4 knobs.PB : Sets the PB audio level of thechannels respectively with theCH-1/2/3/4 knobs.Layout of switch and buttons on the front panel1-7-2. System Adjustment After InstallationObserve the following precautions when this equipment isused for editing system.. The REF. VIDEO IN requires video signal which is inconformity with the RS-170A (525/60).. Adjust the sync phase of this equipment to the systemsync with [SYNC PHASE] control of the setup menu.. Adjust the SCH phase of this equipment to the systemSCH with [SUB CARRIER] control of the setup menu.. When this unit is connected to a switcher that does nothave the sync switching function, the SYNC/BURSTlevel adjustment is required.1. i.LINK button2. VIDEO button3. CH1 1/2 buttonCH2 3/4 button4. VARIABLE switch
