Sony HDR-AS50R Read This First Manual

Also see for FDR-X3000: Service manual Read this first Startup guide Startup guide Help guide

[111] Information PrecautionsOn cleaningClean the camera surface with a soft cloth slightly moistened with water, then wipe the surface with adry cloth. Do not use any of the following as they may damage the finish or the casing.Chemical products such as thinner, benzine, alcohol, disposable cloths, insect repellent, sunscreenor insecticide, etc.Do not touch the camera with any of the above on your hand.Do not leave the camera in contact with rubber or vinyl for a long time.[112] Information PrecautionsOn operating temperaturesThe camera is designed for use in temperatures between –10°C and +40°C (14°F and 104°F).Shooting in extremely cold or hot places that exceed this range is not recommended.[113] Information PrecautionsOn moisture condensationIf the camera is brought directly from a cold to a warm location, moisture may condense inside oroutside the camera. This moisture condensation may cause a malfunction of the camera.If moisture condensation occursTurn off the camera and wait about 1 hour for the moisture to evaporate.Note on moisture condensationMoisture may condense when you bring the camera from a cold place into a warm place (or viceversa) or when you use the camera in a humid place as shown below.When you bring the camera from a ski slope into a warm place.When you bring the camera from an air conditioned car or room into a hot place outside.When you use the camera after a squall or a shower.When you use the camera in a hot and humid place.How to avoid moisture condensationWhen you bring the camera from a cold place into a warm place, put the camera in a plastic bag andseal it tightly. Remove the bag when the air temperature inside the plastic bag has reached theambient temperature (after about 1 hour).