Sony DWZ-M50 Operating Instructions Manual

Also see for DWZB30GB: Brochure Quick start guide Product manual Operating instructions Brochure

20 Receiver SettingsOFF / 1m(3ft) / 1.5m(5ft) / 2m(7ft) /3m(10ft) / 4.5m(15ft) / 6m(20ft) /7.5m(25ft) / 9m(30ft) / 12m(40ft) /15m(50ft) / 18m(60ft) / 21m(70ft) /24m(80ft) / 27m(90ft) / 30m(100ft)4 Select [Set].This completes the configuration, andthe main screen appears again.The cable tone generator will be appliedbefore the equalizer.Configuring the equalizerConfigure the equalizer. Under factorydefault settings, the equalizer is set to 0 dBfor each frequency and the function itself isset to [OFF].1 In the [Setup] screen, select [AudioSetup].The [Audio Setup] screen appears.2 Select [Equalizer].The [Equalizer] screen appears.3 Select [ON] to enable the equalizerfunction, or [OFF] to disable it.If you select [ON], the equalizersettings screen appears.If you select [OFF], configuration iscomplete and the main screen appearsagain.4 Select the frequency for which youwant to adjust the level, and adjust thesetting.5 Select [Set].The setting value is saved.To cancel the setting, press the ESCbutton.Configuring the transmittermuting function for the outputconnectorsYou can select whether to enable themuting function controlled by thetransmitter for the audio output of eachoutput connector. The factory defaultsetting is [To Balanced & Main Only].1 In the [Setup] screen, select [AudioSetup].The [Audio Setup] screen appears.2 Select [TX Muting].The [Apply TX Muting] screenappears.3 Select the connectors for which youwant the muting function enabled.This completes the configuration, andthe main screen appears again.TipScreendisplayConnectorTo AllOutputsToBalanced& MainOnlyTo AUX/TunerOnlyBALANCEDOUTPUTEnabledEnabled–UNBALANCEDOUTPUT MAIN –UNBALANCEDOUTPUT AUX/TUNER– Enabled