80 Making and Checking Network SettingsUHF AccessoriesAN-01 AN-820A WD-850LL L M HAntenna sectionDirectivity Unidirectional Horizontal omnidirectional —Antenna type log periodic dipole array Dipole —Frequency bands 470 – 862 MHz 470 – 542 MHz 556 – 662 MHz 638 – 758 MHz 758 – 862 MHz —Antenna gain: 5 dBi or more (0 dB) —VSWR 2.5 or less — —Half-power angle Within 150 degrees — —FB ratio 12 dB or more — —Booster sectionFrequency bands 470 – 862 MHz 470 – 542 MHz 556 – 662 MHz 638 – 758 MHz 758 – 862 MHz 770 – 810 MHzBooster gain 18 ±2 dB, 10 ±2 dB, 0 +0/–2 dB (switchable) 18 +12 dB (with 12 V DC)10 ±12 dB (with 9 V DC) —VSWR 3.0 or less 3.0 or less —Noise factor 6 dB or less 4 dB or less —Third-order intermodulation 60 dB or more (95 dBμVEMF input) 60 dB or more (85 dBμVEMF input) —Operating voltage 9 V/12 V DC 9 V/12 V DC 100 V AC, 50/60 Hz12 V/9 V DC/OFF, switchableCurrent consumption 100 mA or less 50 mA or less Approx. 14 W (Rated output current 100 mA)Inputs/OutputsAntenna input — — BNC-R × 4 (2 connectors × 2 inputs), 50 ohmsAntenna output BNC-R, 50 ohms BNC-R, 50 ohms BNC-R × 8 (2 connectors × 4 outputs), 50 ohmsCascaded output — — BNC-R × 2 (2 connectors × 1 output), 50 ohmsGeneralOperating temperature 0 to 50 °C 0 to 50 °C 0 to 50 °CStorage temperature –20 to +60 °C –20 to +60 °C –20 to +60 °CDimensions (W × H × D) Approx. 343 × 341 × 36 mm(excl. microphone stand mounting pole/grip) Approx. 70 × 117 × 132 mm Approx. 482 × 44 × 300 mm (excl. protrudingparts)Mass Approx. 530 g Approx. 270 g Approx. 4.6 kgSuppliedaccessoriesMicrophone stand mounting pole/grip (1 set)Stand adapterPF1/2-W5/8 type (1)PF1/2-W3/8 type (1)Operating Instructions (1)Warranty Card (1)Power utility box mounting attachment (1), Wall mounting attachment(1), Microphone stand mounting adapter (PF 1/2 screw) (1), Mountingscrews (1 set), Operating Instructions (1), Warranty Card (1)AC power cord (1), 50-ohm terminator (6),3P-2P adapter (1), Operating Instructions (1),Warranty Card (1)ReferencesNoteOld AN-820A’s are not suitable for to use with DWR-R01D 12V DC power setting. Damage will occur to old AN-820A’s if the DWR-R01D is setto 12V.