Sony DVX-11A Installation And Connections

Also see for DVX-11A - Car Mp3/dvd/cd Single Player: Limited warranty Installation/connections Operating instructions Operating instructions Installation/connections

© 2003 Sony Corporation Printed in JapanDVX-11A3-255-986-21 (1)Installation/ConnectionsMobile DVDPlayerFoot brake type Hand brake typeParking brake switch cord4Using the tapcConnection boxFront speaker (Left)Rear speaker (Left)SubwooferMedia center main unitFront speaker (Right)Rear speaker (Right)Headrest MonitorOverhead monitorSony DVD player DVX-11A2Parking cord (Light green) of 22Parking brake switch cordParking brake switch cord3Cautions•This unit is designed for negative ground 12 VDC operation only.•Do not pinch wires under screws, or in movingparts (e.g., seat railing).•Before making connections, turn the carignition off to avoid short circuits.•Connect the yellow and red power input leadsonly after all other leads have been connected.•Run all ground wires to a common groundpoint.•Be sure to insulate any loose unconnectedwires with electrical tape for safety.•The use of optical instruments with thisproduct will increase the risk of eye injury.•Control adjustments and procedures otherthan those specified herein may result inhazardous radiation exposure.•For your safety, the monitor connected to theFRONT VIDEO OUT can only be viewed whenthe car is stopped and the parking brakeapplied.Be sure to connect the parking cord (Lightgreen) of 2 to the car’s parking brake switchcord.Notes on the power supply cord (yellow)•When connecting this unit in combination withother stereo components, the connected carcircuit’s rating must be higher than the sum ofeach component’s fuse.•When no car circuits are rated high enough,connect the unit directly to the battery.Parts Iist (1)The numbers in the list are keyed to those in theinstructions.Installation diagram (2)Example:Dashboard installation.NoteAll the equipment other than the Sony DVD playerDVX-11A and the remote control sensor is notsupplied.Connecting the parking brakecord (3)Be sure to connect the parking cord (Lightgreen) of 2 to the parking brake switch cord.The mounting position of the parking brakeswitch cord depends on your car. Consult yourcar dealer or your nearest Sony dealer forfurther details.Using the tapAttach the tap 4 to the end of the parking cord(Light green) of 2 and the parking brake switchcord.NoteIf the parking brake switch cord is too thin, connectthe parking cord (Light green) of 2 to the parkingbrake switch cord directly without using the tap 4.Connection diagram (4)1 To a metal surface of the carFirst connect the black ground lead, thenconnect the yellow and red power input leads.2 To the +12 V power terminal which is energizedin the accessory position of the ignition keyswitchNoteIf there is no accessory position, connect to the+12 V power (battery) terminal which isenergized at all times.Be sure to connect the black ground lead to ametal surface of the car first.3 To the +12 V power terminal which is energizedat all timesBe sure to connect the black ground lead to ametal surface of the car first.4 To the parking brake switch cord5 To a digital amplifier or audio deviceConnect the optical cable RC-97/98 (notsupplied), etc., to a digital amplifier or audiodevice equipped with a Dolby digital decoder.1× 45 63243PM3 × 63T5 × 81

/ 4

Related manuals for Sony DVX-11A - Car Mp3/dvd/cd Single Player