Chapter 6 Editing 6-9Chapter 6 EditingMonitoring signals during previewingDuring previewing, you can monitor the followingvideo and audio signals on a monitor connected to therecorder VTR:• Between preroll and IN points: Playback signal ofthe recorder VTR can be monitored.• Between IN and OUT points: Playback signal of theplayer VTR can be monitored in E-E mode.• Between OUT and post-roll points: Playback signalof the recorder VTR can be monitored.This may be illustrated as shown below:6-1-8 Modifying Edit PointsIf an edit point is incorrectly set, for example, if anOUT point is located before an IN point, or the lengthof an edit section is different for the recorder andplayer VTRs, the time data for the incorrectly set editpoint flash indicating that the VTR cannot performediting or previewing. In this case, delete the editpoint, then set a new one correctly.You can also move an edit point position in one-frameunits.Deleting edit pointsDeleting edit points1 Press the RECORDER or PLAYER button toselect the VTR on which to perform the edit pointdeletion.The button lights up.2 Press the IN, OUT, AUDIO IN or AUDIO OUTbutton while holding down the CLR button todelete the corresponding edit point.The edit point is deleted and --:--:--:-- appears inthe menu display.$$PB(recorder VTR)IN pointEE(player VTR)OUT pointPB(recorder VTR) 12
