Sony DVW-522 Operation Manual

Also see for 10001: Installation manual Installation manual Maintenance manual Maintenance manual Maintenance manual

2-1 Control PanelChapter 2 Locations and Functions of Parts and Controls2-10 Chapter 2 Locations and Functions of Parts and Controls5 CONTROL PANEL connector (D-sub15-pin)Connects the control panel through the 15-pin cablesupplied in the optional BKDW-510 Control PanelExtension Kit to allow the control panel to be used in aremote control configuration.6 MONITOR OUTPUT connectors (XLR-3-32)Output signals to the audio monitor in two signal lines:L and R. The signals to be output are selected with theMONITOR SELECT buttons on the upper controlpanel.By selecting the output signals, you can adjust thevolume level with the PHONES level control on theupper control panel.For details, refer to the Maintenance Manual Part 1.Notes• If you connect a transformer-less CANNON to PINconverter to the MONITOR OUTPUT connectors toobtain unbalanced output, it is recommended that youchange the level of the output signals from +4 dB(standard) to 0 dB beforehand. If the level of theoutput signal is kept at +4 dB, distortion may occurwhen the output level is close to full scale.For details on changing the output signal level, refer to theMaintenance Manual Part 1.• If you use the converter mentioned above and anRFU adaptor kit at the same time, audio signal-induced beat interference may occur in the videosignals output from the RFU adaptor kit.If you wish to use the converter and the adaptor at thesame time, consult with Sony service personnel.7 RS232C connector (D-sub 25-pin)Accepts or sends RS-232C remote control signals and/or VTR status data from/to external equipment.2-3 Connector Panel