Sony DFP-R3000 Installation Manual

Also see for DFP-R3000: Quick start guide Operation guide Quick start guide

1-18 (E) DFP-R3000ProcedureStep 1. Installing the Adapter (A) Assembly to theProjector1. Remove the REEL ARM or platter guide roller of thesupply reel side from the projector.2. Place the three spacers (EA) between the adapter (A)and projector, and tentatively secure it with the threehexagon cap screws (5/16) 1, three spring washers(SW8), and three washers (W8).nThe installing position of the adapter (A) and spacer(A) differs according to the projector. (See the figurebelow.)3. Attach the path adjustment tool tentatively to theadapter (A) with the two hexagon cap screws (M4 x12) 2, two washers (W4) and two spring washers(SW4) at the position shown in the figure.4. Put a film on the path adjustment tool (roller) from theprojector, and adjust the attaching position of the pathadjustment tool so that the film is smoothly fed ontothe projector.5. After the adjustment has been completed, tighten thetwo hexagon cap screws (M4 x 12) 2.6. Put a film on the path adjustment tool (roller) from theprojector, and adjust the attaching position of theadapter (A) so that the film is smoothly fed onto theprojector.Especially adjust so that the tension on both edges ofthe film is even.7. After the adjustment has been completed, tighten thetwo hexagon cap screws (5/16) 1.8. Remove the film from the path adjustment tool.9. Remove the path adjustment tool from the adapter (A).ProjectorNORELCOAA-II 35/70Path adjustment toolSpacer(EA)Adapter (A)Spacer(EA)1 Hexagon cap screw(5/16)Washer (W8)11222Hexagon cap screw(M4 x 12)Hexagon capscrew (M4 x 12)Spring washer(SW4)Spring washer (SW4)Washer (W4)Washer (W4)Spring washer(SW8)Path adjustment toolPath adjustment toolFilmAdapter (A)