90 Selecting the Native Scan/Scan ModeChapter 4 OperationsSelecting the NativeScan/Scan ModeYou can select scan mode from a native scan, under scan(–3%), normal scan (0%) and over scan (mask of 5% overscan portion in the normal scan picture).You can set scan mode with the NATIVE SCAN button orSCAN button of the controller, or in the Function Switchmenu of the Function Setting menu.Setting with the NATIVE SCAN button orSCAN button of the controllerTo set to the native scan modeSet the NATIVE SCAN button to on. (The LED on thebutton lights.)To select the scan mode1 Set the NATIVE SCAN button to off. (The LED onthe button is turned off.)2 Press the SCAN button to select the scan mode.Scan mode is changed to normal, under and over scanmode by each press of the button.Setting in the menuSet Scan Mode or Native Scan in the Function Switchmenu (page 67) of the Function Setting menu.To set to the native scan modeSet Native Scan to On.To select the scan mode1 Set Native Scan to Off.2 Select Scan Mode, then select scan mode from thefollowing.Normal Scan: Normal modeUnder Scan: Under modeOver Scan: Over modeThe scan mode is not selectable in the following cases:• When Native Scan is set to On• When the internal signal is displayed• When Side by Side is set to OniiFunction Switch 1/5Scan Mode: xxxNative Scan: xxx16:9: xxxH Delay: xxxV Delay: xxxExternal Sync:: xxxComb: xxxvVNote
