Sony BDX-D1000 Installation Manual

1-4 (E) BDX-D10006. Attach the front and rear brackets to the outside of therack temporarily using the eight screws (B5x8)supplied with RMM-30.7. While pressing the stoppers of the inner rails, slide theinner rails fully into the outer rails.w. Be sure to mount the BDX-D1000 in the rack with twoor more persons.Trying to handle this job by one-person could occur toinjury.. Be careful not to get caught your hand and finger in therack mount rail when installing the unit in the rack.8. After confirming that the BDX-D1000 can be movedsmoothly, tighten the screws (B5x8) secured tempo-rarily in the step 6.nWhen securing the front brackets to the rack byscrews, pull out the BDX-D1000 about 20 cm (8inches), and fasten the screws of the front brackets tothe rack.9. After installing the BDX-D1000 in the rack, secure theunit to the rack by the prepared four screws (RK5x16)and four washers.nWhen the BDX-D1000 is mounted in a rack, the maximumtraveling distance is illustrated below.1-4. Rack MountingRK 5x16WashersWashersRK 5x16RackRackRackUnit : mm12.712.731.7512.731.75B 5x8B 5x8Outer railsFront bracketRear bracketRackStopperInner railOuter rail8844581 (Maximum traveling distance)Distance to the center of the side railHeight of the unit mounted in a rack Unit : mm