1GUIDE0467891235DIGITALMEMORYSTICKMODEINDEXPROGMENUVIDEO TV/ /VTRTVDVDQuick Start Guide4-090-228-01Checking the suppliedaccessoriesInserting batteries intothe remote controlConnecting the TV2Remote ControlConnecting an aerial onlyConnecting an aerial and VCRKD-32NX200UThank you for choosing this SonyTrinitron Television.This step by step guide will help you to:Insert batteries into the remote control.Connect the aerial to your TV.Connect a video cassette recorder (VCR) to your TV.Switch on your TV.Tune your TV.View TV programmes.1 3KD-36NX200UBatteriesRF Loopthrough cable32Place a coin in the slot at thebottom of the remote control.Turn anti clockwise to releasethe battery compartment.Insert the batteries asindicated in the batterycompartment. Replace the battery compartmentand lock in place by twisting thecoin clockwise in the slot.Always remember to dispose of batteries in an environmentally friendly way.R/D/D/D L/G/S/IANALOGUE12DVDVCRs 33(SMARTLINK)DIGITALOPTICAL OUTPUTMODEM . . . 5V 200mAExistingaerial leadRF loopthroughcable (supplied)Scart lead(not supplied)RF lead(not supplied)1. Connect your existing aerial lead to the digital socket marked on the rear ofthe TV as shown.2. Connect the supplied RF loopthrough cable from the socket marked to theanalogue socket marked .1. Connect your existing aerial lead to the digital socket marked on the rear of theTV as shown.2. Connect the supplied RF loopthrough cable from the lower socket marked onthe TV to the RF IN socket on your VCR.3. Connect a lead from the RF OUT socket of your VCR to the analogue socketmarked on the TV.4. Connect a scart lead from the socket marked on the rear of the TV tothe scart socket on your VCR (refer to your VCR instruction manual).5. Connect the VCR to the mains socket and switch on.6. Insert a pre-recorded tape into the VCR and press the ‘PLAY’ button. This enablesthe TV to locate and store the video channel during the ‘Automatically tuning theTV’ procedure.s 33VCR