Quick Start Guide4-090-013-01Checking the suppliedaccessoriesBatteriesInserting batteries intothe remote controlConnecting the TV2Remote ControlAlways remember to:• observe the correct polarity when inserting batteries,• dispose of batteries in an environmentally friendly way.1. Connect your aerial lead to the aerial socket labelled 8 on the rear of the TV.Connecting an aerial only1. Connect your aerial lead to the IN* socket on your VCR.2. Connect an RF lead from the OUT* socket on your VCR to the aerial socket labelled8 on the rear of the TV.3. Connect a fully wired 21-pin scart lead from the scart socket marked i3/r3 on therear of the TV to a scart socket on your VCR**Notes: *Socket names may vary depending on make and model of VCR. Refer to yourVCR instruction manual for details.**If your VCR does not have a scart socket follow the connecting instructions aboveignoring the scart lead connection.You will also need to manually tune the VCR to a spare TV channel (ideally channel0, refer to the ‘Manual Programme Preset menu’ section of the main instructionmanual).Connecting an aerial and VCRKV-32FQ80UThank you for choosing this SonyTrinitron Television.This step by step guide will help you to:Insert batteries into the remote control.Connect the aerial to your TV.Connect a video cassette recorder (VCR) to your TV.Switch on your TV.Tune your TV.View TV programmes.VCRVCR TV DVDMODER/D/D/D L/G/S/IANALOGUE12DVDVCRs 33(SMARTLINK)s 44DOLBY. THE DOUBLE-D SYMBOL DARE TRADEMARKS OF DOLBYLABORATORIESDR/D/D/D L/G/S/IANALOGUE12DVDVCRs 33(SMARTLINK)s 44DOLBY. THE DOUBLE-D SYMBOL DARE TRADEMARKS OF DOLBYLABORATORIESDRF lead(not supplied)Scart lead(not supplied)1 3231KV-36FQ80U