Silvercrest SL 65 Operating Manual

Also see for SL 65: Operating manual

Contents

Overview of EquipmentFront side of the receiverRear side of the receiverRemote controlOverview of EquipmentFront side of the receiver1 LED display Shows channel location or ttime2 – Infrared sensor for the signal of the remote control3 LED POWER LED is illuminated if the receiver is switched on or instandby mode4 OK Confirm5 MENU Invokes main menu6 VOL + Increases volumeCursor moves to the right7 VOL – Decreases volumeCursor moves to the left8 CH + Switches to the next higher channel locationCursor moves up9 CH – Switches to the next lower channel locationCursor moves down10 POWER Switches on and switches to the standby modeRear side of the receiver1 RF OUT LNB connection for a second satellite receiver2 LNB IN LNB connection for the antenna cable3 VCR SCART connection for the video set4 TV SCART connection for the TV set5 100 – 240 V~ Mains connection50/60 Hz, 30 W6 0/1 Mains switch7 S-VHS S-Video connection8 COAXIAL Digital coaxial audio output9 OPTICAL Digital optical audio output10 RS 232 Serial port11 VIDEO Analog video connection12 AUDIO L Left analog audio connection13 AUDIO R Right analog audio connection