Silvercrest SL 35 Operating Manual

Overview of equipmentFront side of the receiverRear side of the receiverRemote controlOverview of equipmentFront side of the receiver1 – Infrared sensor for the signal of the remote control2 LED STBY LED is illuminated if the receiver is in standby mode3 LED ON LED is illuminated if the receiver is switched on4 CH – Switches to the next lower channel locationCursor moves down5 CH + Switches to the next higher channel locationCursor moves up6 STANDBY Switches on and switches to the standby mode.The default settings will be restored if you keep this keypressed for more than 10 seconds.Caution! By doing this, your personal settings will bedeleted.Rear side of the receiver1 LNB IN LNB connection for the antenna cable2 IF OUT LNB connection for a second satellite receiver3 VCR SCART connection for the video set4 TV SCART connection for the TV set5 100 – 240 V~ Mains connection50/60 Hz, 20 W6 ON/OFF Mains switch7 RS 232 Serial port8 COAXIAL Digital coaxial audio output9 AUDIO L Left stereo audio connection10 AUDIO R Right stereo audio connection100% Black+Silverfor light surfaces#Faulty-Description:GuaranteeSender please use block-writing in boxes with CAPITAL LETTERSSurnameFirstnameStreetPostcode and cityTelefon no. with areacodeSignature of buyerPleaSe cut thiS carD anD enclOSe it tO the returninG GOODcOMaGService centreunit 1 longsindustrial estateenglands laneGorleston GreatYarmouthnorfolk nr31 6BeService-hotline:00 44 (0) 8708 900137e-mail:info@comag-ag.co.ukModel / type: Sl 35• •frompurchase-date••••36months••Guarantee