Siemens sinumerik 840D sl Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

Contents

TurningOperating Manual, 07/2010, 6FC5398-8CP40-0BA0 649Service Planner (828D only) 1919.1 Performing and monitoring maintenance tasksWith the "Service Planner", maintenance tasks have been set up that have to be performedat certain intervals (e.g. top up oil, change coolant).A list is displayed of all the maintenance tasks that have been set up together with the timeremaining until the end of the specified maintenance interval.The current status can be seen in the status display.Messages and alarms indicate when a task has to be performed.Acknowledging a maintenance taskAcknowledge the message when a maintenance task has been completed.NoteProtection levelYou require protection level 2 (service) to acknowledge completed maintenance tasks.Service PlannerDisplay MeaningPos Position of the maintenance task in the PLC interface.Maintenance task Name of the maintenance task.Interval [h] Maximum time until next servicing in hours.Remaining time [h] Time until the interval expires in hours.Status Display of the current status of a maintenance task.The maintenance task has been started.The maintenance task is completed.The maintenance task is deactivated.