Siemens sinumerik 840D sl Operating Manual

Also see for SINUMERIK 828D Turning: Diagnostic manual Function manual Equipment manual Programming manual Operating manual

Contents

TurningOperating Manual, 07/2010, 6FC5398-8CP40-0BA0 107Machining the workpiece 44.1 Starting and stopping machiningDuring execution of a program, the workpiece is machined in accordance with theprogramming on the machine. After the program is started in automatic mode, workpiecemachining is performed automatically.RequirementsThe following requirements must be met before executing a program:● The measuring system of the controller is referenced with the machine.● The necessary tool offsets and work offsets have been entered.● The necessary safety interlocks implemented by the machine manufacturer are activated.General sequence1. Use the Program manager to select the desired program.Select the desired program under "NC", "Local drive", "USB" or set-upnetwork drives.3. Press the "Select" softkey.The program is selected for execution and automatically switched tothe "Machine" operating area.4. Press the key.The program is started and executed.NoteStarting the program in any operating areaIf the control is in "AUTO" mode, you can also start the selected program when you are inany operating area.