7ML19985QA82 SITRANS LR 300 ñ QUICK START MANUAL Page EN-5mmmmmEnglishLocal ProgrammingThe hand programmer is used for local programming sequences. Hold the programmer closeto the unit (within 15cm [6î]), and point it directly at the bottom of the display to activate theprogramming options.PROGRAM Mode:The PROGRAM key toggles between RUN and PROGRAM mode.The EDIT icon appears when you key in a new value: it remains visible until you press theENTER key and the new value is accepted.Switching from RUN to PROGRAM mode:Press to activate PROGRAM mode: the number fields go blank.Accessing a parameter: scroll to the parameter number, or follow these steps:1. Press to display the Parameter Number field.2. Press again to open the Parameter Numberfield. The field goes blank and the EDIT iconappears3. Key in the desired parameter number:Example: . The new parameternumber and value appear.Changing a parameter value:1. Key in the new value. (The new value and the EDIT icon appear.)2. Press to set the value. The EDIT icon disappears.Resetting an individual parameter to Factory Setting1. Scroll to the parameter or key in its address.2. Press .3. The value field goes blank and the EDIT icon appears.4. Press . The value returns to factory default and the EDIT icon disappears.Note: Values shown are for demonstration purposes only.Key Programming ModeClear valueToggle between Units and % on parameter valueToggle between PROGRAM and RUN modeUpdate echo quality parametersParameter scroll-upParameter scroll-downToggle fieldsEnter the displayed valuehandprogrammerdisplaymax. 150 mm (6")parameter valueparameternumberedit icon