Siemens SIREMOBIL Iso-C Troubleshooting Manual

Also see for SIREMOBIL Iso-C: Installation instructions Installation and setting instructions Service instructions Installation and setting instructions Service instructions

76 Adjustments / ProgramsSIREMOBIL Iso-C SPR2-230.840.01.01.02 © Siemens, 200808.08 CS PS SPPage 76 of 148For internal use onlyUnit serial number Enter the serial number of the SIREMOBIL Iso-C when it isequipped with a DICOM bridge. The serial number isrequired to identify the images transferred. Please note thatyou have to omit the leading 0 when entering the serial num-ber.Disable dose rate selection inuser setupThis means "Yes" for SIREMOBIL Iso-C without a dose-areaproduct measurement device. This means "No" for a SIRE-MOBIL Iso-C with an dose-area product measurementdevice.Subtraction K-factor, phase A Noise suppression, phase A, is programmed in the SUB-mode. Phase A: Mask acquisition.Subtraction K-factor, phase B Noise suppression, phase B, is programmed in theSUB-mode. Phase B: Acquisition of fill image.Subtraction Time of phase A The time of phase A in the SUB-mode is programmed.Phase A: Mask acquisition.Roadmap K-factor, phase A Noise suppression, phase A, is programmed in the roadmapmode. Phase A: Mask acquisition.Roadmap K-factor, phase B Noise suppression, phase B, is programmed in the roadmapmode. Phase B: Acquisition of fill images.Roadmap K-factor, phase C Noise suppression, phase C, is programmed in the roadmapmode. Phase C: Acquisition of roadmap images.Roadmap Time of phase A The time of phase A in the roadmap mode is programmed.Phase A: Mask acquisition.(1) in menu DiagnosticsFunction: Comments: