Procedure1. The tool list is opened.2. Place the cursor on the tool that you want to load into the magazine (ifthe tools are sorted according to magazine location number you will findit at the end of the tool list).3. Press the "Load" softkey.The "Load to… " window opens.The "... location" field is initialized with the number of the first empty mag‐azine location.4. Press the "OK" softkey to load the tool into the suggested location.- OR -Enter the location number you require and press the "OK" softkey.- OR -Press the "Spindle" softkey.The tool is loaded into the specified magazine location or spindle.Loading empty magazine location directly with tool1. Position the cursor at an empty magazine location where you want toload a tool and press the "Load" softkey.The "Load with ..." window opens.Select the desired tool in the " ... Tool" field and press the "OK" softkey.Several magazinesIf you have configured several magazines, the "Load to ..." window appears after pressing the"Load" softkey.If you do not want to use the suggested empty location, then enter your desired magazine andmagazine location. Confirm your selection with "OK".Multiple load pointsIf you have configured several loading points for a magazine, then the "Loading PointSelection" window appears after pressing the "Load" softkey.Select the required loading point and confirm with "OK".Unloading tools1. Place the cursor on the tool that you would like to unload from the mag‐azine and press the "Unload" softkey.2. Select the required load point in the "Loading Point Selection" window.Tool management11.5 Tool listUniversal228 Operating Manual, 05/2017, A5E40868517
